PROZRTED faucet control recirculating pump can work with different water heaters tanked, tank-less etc. Just turn on hot water faucet for 2 seconds to activate the pump to work, the instant hot water will be available in a few minutes. Easy to use and super energy saving. HBS24-12Z was designed to be installed under the farthest faucet from the water heater in each loop. NSF certified. Lead-free copper. Safe for drinking water. Maintenance-free. 1/2" NPT. 10 ft cord and is easy to install.
High-tech and highly accurate built-in water flow sensor and two built-in thermostats. (One to measure the pipe water temperature and the other one to measure the pump ambient air temperature). High flow and high lift smart pump with digital permanent magnet brushless 24v DC motor ensures high-speed circulation. Just turn on the hot water faucet for 2 seconds and turn it off. The instant hot water will be available in a few minutes. High speed, super quiet, and safe.
Three modes are available. Smart mode Instant hot water is always available. Energy-saving mode If you don't use the hot water for some time, the pump will decrease the temperature set point automatically. Manual mode the most energy-saving mode, just start the pump a few minutes before you need the hot water. 3 running speed. Smart memory function. The pump can remember the last settings when it was powered off. Work well with the smart plug.
Super energy saving application recommendation Set the pump in “manual mode”. Start the pump by turning on the faucet for two seconds. The pipe water will reach the set temperature in a few minutes. And then the pump will shut off. Care about your water heater (Longer life no more frequent start). Save gas, save water. High flow (6.1GPM/366GPH max) and high lift (39.3ft max). It only takes a few minutes from turning on the pump until the hot water in the pipe reaches the set temperature.
Built-in check valve. The pump default temperature is 38 ℃ off and 33 ℃ on. When the water temperature in the pump is below 33 ℃ (91.4F), the pump will push the cold water back to the water heater. As the temperature hits 38 ℃(100.4F), the pump will shut off automatically. A remote controller was used to set higher or lower water temperatures (From 32 to 42 ℃ ). The remote control is not included in this package.
[Multiple Remote Control] one pump can be paired with up to 5 remote controls. Control your pump at different locations in your home. The maximum distance between the remote controland the pump is 30 feet, with a maximum of one wall
